You can attach your Awning to your wind out canopy by simply winding out the canopy to head height, attach the driveaway fixing kit to the beading section of the canopy. lift the tunnel section of the awning up to the canopy, slide it on to the figure of eight of the driveway fixing kit and then wind your canopy in. This will lift up your tunnel to the desired position.
Peg out the base of the tunnel under the Motorhome in order to get it as close to the Motorhome as possible. Finally proceed to erect the rest of your awning.
If you do not have a canopy either use a C Channel or you can throw the straps (which come supplied) over the roof and peg them down on the other side of you Motorhome.
The tunnel is merely to act as an umbrella effect to give you some protection from the elements; your habitation area will give you a wind tight seal and gives you full protection.
